-
Created by Thursday, March 22, 2012 7:40 AM
Size: 900 × 487 (226 KB)
-
Created by Thursday, March 22, 2012 7:40 AM
Size: 956 × 501 (177 KB)
-
Launch peg reinforcement on ext. wing
Created by Saturday, October 8, 2011 11:55 AM
Size: 1024 × 768 (90 KB)
-
Created by Saturday, October 8, 2011 11:55 AM
Size: 1024 × 768 (96 KB)
-
Created by Saturday, October 8, 2011 11:55 AM
Size: 1024 × 768 (114 KB)
-
boom3 · Tapered carbon boom cut from a cheap Walmart fishing rod. 4.1 grams
Created by Tuesday, July 19, 2011 5:10 AM
Size: 814 × 340 (185 KB)
-
Ricks_Bug · Covered all over with Doculite.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (127 KB)
-
Tail_detail1 · Teflon tubes glued to small angled blocks for support. Small piece of servo wire insulation makes a keeper for the pushrod at the horn.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (126 KB)
-
pushrods · Pushrods in teflon glued to small blocks and fuse sides for support.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (123 KB)
-
tail_detail3 · Teflon tubes glued to small angled blocks for support.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (107 KB)
-
pushrod_exit · 0.018" music wire pushrods in teflon tubing exit just above boom. Tubes are glued with CA along the length of the boom.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (63 KB)
-
Guts1 · Two Dymond D47 servos in a brick- plenty of room
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (138 KB)
-
Guts2 · Electrical gear. A Rhino 360mah lipo is in the compartment forward of the Rx.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (152 KB)
-
tail_detail2 · Boom is let into the vert, but not slotted, reinforced with light glass and CA. Tail surfaces covered with Doculite.
Created by Tuesday, July 19, 2011 5:10 AM
Size: 1024 × 768 (124 KB)
